This section describes how to block a key on iLOQ Manager.
This function is used to prevent a lost key from accessing the locks. The lock re-programming must be carried out by using the Programmer, or through the network.
An alternative way to blacklist a key is to blacklist it by a replacement key. For more information, see sections Creating a New Replacement Key and Converting an Existing Key to a Replacement Key.
Proceed as follows.
- Select .
- Select Add to blacklist.
The Add to blacklist wizard is opened.
- Select Add a key to the blacklist.
- Select the key that you want to add to the blacklist.
- Select Next.
- Select how to proceed with the locks affected.
The options are:
Leave locks in planning state — Select Leave locks in planning state if you want to leave the locks in the planning state, and program the locks later.
Order locks — Select Order locks if you want to create the programming task, but execute it later, or program networked locks.
Order and program locks — Select Order and program locks if you want to create the programming task, and execute it at once for a single lock at hand.
Order and transfer tasks to programmer — Select Order and transfer tasks to programmer if you want to create the programming tasks, transfer them to the Programmer, and take the Programmer with you to program the locks at the site. If you have networked locks, this option will also program them through the network.
- Select Next.
- A summary screen is shown.
- Follow the wizard to end the procedure.